D-280

  • D-280
  • D-280
  • D-280
  • D-280
  • D-280
  • D-280
  • D-280
  • D-280
D-280
  • Product Introduction

Device parameters:

1552356529367095434.jpg

Features of equipment:
Large shaping size of equipment

Maximum molding size 250mm X 250mm X 100mm suitable for large surface processing of steel bracket

Compatible with minimum molded size 150mm × 150mm × 100mm for printing with a minimum number of around 200 crowns each time

Equipment, laser power
The maximum laser power of 500W, life of 100,000 hours, effectively ensure the utilization rate of equipment
The surface of the bottom crown of the denture is smooth
The D-280 uses Germany's most advanced lasers and dynamic aggregation scanning lenses to obtain high-quality light spots. The diameter range is 20-50 microns. After the metal powder melts, the surface of the bottom crown of the denture has a very high degree of finish. The surface roughness: Ra2 .5
Equipment unique variable speed scraper technology
Variable speed scraping powder technology, reduce the time spent on the empty stroke, thus improving the efficiency of the equipment. Single layer powder only needs 5S, sweep speed up to 7000 mm/s
Equipment processing materials
The equipment can be compatible with the printing of cobalt Chromium alloys and titanium alloys(cobalt Chromium alloys protected by nitrogen, titanium alloys protected by argon)
The device uses a completely new atmosphere control technology.
The atmosphere control technology can reduce the replacement time and reduce the consumption of inert gases. During the molding process, the oxygen content ≤ 50 PPM. Gas consumption is small, only 1-3 L/min

Previous
Next